How to solve the failure of accumulator during use

Some users are using Accumulator During the process, I encountered the phenomenon of equipment failure. Once the equipment fails, it will affect the normal use. If the equipment is not used normally, the work will naturally be adversely affected. Therefore, users should pay attention to prevent malfunctions when using the equipment, and solve them in time if they occur.

How to solve the accumulator failure during use? For this, everyone must check the equipment to find the specific cause of the failure, and then decide which method to solve, treat symptomatically, and ensure that the failure problem can be resolved after a series of treatments. For example, the damage of the nitrogen diaphragm often makes it difficult for the accumulator to assume the role of buffering and damping, which leads to its failure. In this case, when inspecting the equipment, you can gently press the probe on the detection valve with your hand. If you can easily press it down, it means that there is no nitrogen, and it is likely that the diaphragm is damaged. For this failure, the diaphragm can be replaced and silicone oil applied to the edge can be effectively solved.

However, if the O-ring seal is prone to aging and failure after long-term use, causing the price of the accumulator to fail, the nitrogen pressure of the equipment drops quickly during the inspection, or there is an oil leakage in the seal ring, and the seal needs to be replaced for this failure. To solve the problem, tighten the detection valve nut.